Category: Overig
De switch- en keycap-trekker is ontworpen om switches en keycaps optimaal en veilig van een toetsenbordplaat te verwijderen.
Laat uw e-mailadres achter bij 'Stel mij op de hoogte' als het productmodel niet op voorraad is.
Finally, a puller that actually gets the job done without bending pins—the prongs fit snugly into the keycap gaps and pop them off cleanly. I've been using it to swap out switches on my board, and the metal wire handles the removal with zero wobble.
The prongs grip switches firmly without bending pins, and the wire loops slide under keycaps effortlessly. No more worrying about scratching my keyboard plate during swaps.
Finally got this after using a paperclip for too long—the switch side grips firmly without scratching the plate. Pulled off a whole board of Cherry browns in under two minutes with zero bent pins.
The prongs on this puller are sturdy enough that I don't worry about scratching my board's plate. It made swapping out a batch of linears a quick, painless job.
The wire loops grip both switch and keycap stems firmly without scratching, which made swapping my keyboard's layout a quick ten-minute job.
The handle gives me just enough grip to pop off even tight keycaps without any damage to the board. Works perfectly for both switches and caps, and it's much easier than using my fingers.
Pulled a couple of stubborn switches that were really stuck in the plate without bending any pins, and the keycap hook works perfectly too. The grip is solid and it feels sturdy enough for daily use.
Finally, a tool that doesn't scratch the plate when prying off switches—those curled wire ends grab each corner evenly. It's lightweight but feels sturdy enough for daily swaps, and it makes removing keycaps from a standard board effortless.
Pulling switches used to feel like a gamble until I got this tool — the dual-ended design makes removing both keycaps and switches effortless. The metal handles have a nice grip that keeps my fingers from slipping mid-pull.
The wire loops are just the right thickness to slide under switches without scratching the plate, and I’ve pulled over 50 keys without any bending.